Before installing a new shower drain, you must first cut the old one. Break the concrete to create a trench that is a little deeper than the new one. Measure the size of the drain pipe. It must be at least one and a half inches longer than the old one. Be sure to choose the right material and length. SCH 40 is the most common size and 1/2 inches wide is the most common material.
To start relocating the existing drain, break up the concrete slab around it. Use a hammer and chisel to break off the concrete and expose the flange of the new drain. Once you have located the flange of the old drain, loosen the bolts securing it. Once you’ve removed the cover, unscrew the nut and wrench. Make sure to keep the crayon marks visible during the cutting process.
Next, set the drain in place by putting it over the pipe and set it back over the concrete. You may need to cut the concrete slab to get to the drain, and then mark it with a pencil to mark the path you need to follow. If you’re moving an existing drain, pick the route that reaches the other drain the easiest. Remember, you can’t rip up the old concrete if the new one isn’t flush with it, so you must carefully cut the edges.
If you’ve already cut the concrete around the drain flange, you can remove the cover with a hammer. Using a chisel, you can break the concrete and expose the flange. Then, use a wrench to loosen the bolts and remove the old drain. When you’re finished, you’re ready to put in the new drain. If you’re having trouble, you can buy a new one at a hardware store.
The best way to install a shower drain in concrete floor is to use a hammer and a sharp hammer. You will need to break up the concrete to remove the old drain. You can use a sharp tool to cut the pipe and the drain connection to it. It’s important to measure accurately so that you can ensure it fits correctly. When you’re finished, you should place the drain cover over the pipe.
You should prepare the work area by first removing the concrete around the drain flange. You should use a hammer to break the cement off. Once you’ve removed the concrete from the flange, you can then apply the concrete around the drain. Then, you should smooth the concrete around the drain flange using a flat metal trowel. Finally, you should install the drain cover by removing the duct tape.
After installing the new drain, you must take measurements to make sure that the new one fits well. You should measure the depth of the drain and the width of the pipe stack. You’ll need to determine the height of the existing wall. If the walls are higher than the ceiling, you’ll need to cut holes in them to accommodate the new pipe. You should also consider the length of the plumbing pipes. During the installation process, you should carefully place the pipes so that they don’t interfere with each other.
Once the drain has been placed in the concrete, you must install the pan liner. You should apply a bead of 100% silicon caulk around the upper surface of the drain. The caulk will protect the subfloor from water and prevent the drain from leaking. Once the drain is in place, you should cut the cement around it. Alternatively, you can use a cement adhesive to fix the pan liner to the concrete floor.
After installing the new drain, you need to move the existing drain connection. If you’re transferring the old drain to the new one, you’ll need to break up the concrete slab to move it. You’ll need to cut the old drain connection, so you’ll need to use a reciprocating saw. Afterwards, you’ll need to mark the bottom of the horizontal pipe so it’s parallel to the new pipe.